Replacing Blades Salvation 1 and 3 Helicopters

Step 1) Remove CAP from top of helicopter

 

Step 2) Holding tightly onto the body of helicopter place two fingers underneath the TOP BLADE and lift upwards

 

Step 3) Remove SPACER

Step 4) Remove both GROMMET and WASHERS, grommet clip is tightly fitted.

 

Step 5) Remove BOTTOM BLADE.

 

NOTE: When replacing blades please ensure there is a 1mm gap between the bottom blade and gear cog to enable bottom blade to spin freely and prevent uncontrollable spinning. Do not totally detach link between gear cog and bottom blade, these parts need to spin jointly.

 

Remove parts carefully

Tongue and Grove Joint Note: Do not totally detach link between gear cog and bottom blade, these parts need to spin jointly.

Related Faqs

• Tail and Boom Replacement Procedure Salvation 1, 3 and 9
• Replacing Axle Parts On Salvation 9 Helicopter
• Replacing Blades Salvation 9 and 11 Helicopters
• Battery Replacement Procedure Salvation 1, 3 and 9 Helicopter
• Motor Replacement Procedure Salvation 1 , 3 and 9 Helicopter