Replacing Axle Parts On Salvation 9 Helicopter

Please ensure a firm grip is applied on both helicopter body and underneath balance bar when removing Top Blade from Salvation 9 Helicopter. Diagram 1

Step 1- Place both fingers underneath Top Blade and grip helicopter body firmly. Lift upwards and remove top section.

Step 2- Remove both Spacers and Washers. Diagram 2

Step 3- Remove Bottom Blade

 

Note: When replacing new parts please ensure there is a 1mm gap between the bottom blade and gear cog (tongue and grove joint) to enable bottom blade to move freely. If tightly connected this may cause helicopter to spin uncontrollably.

 

Diagram 1	Diagram 2

 

Related Faqs

• Tail and Boom Replacement Procedure Salvation 1, 3 and 9
• Replacing Blades Salvation 9 and 11 Helicopters
• Replacing Blades Salvation 1 and 3 Helicopters
• Battery Replacement Procedure Salvation 1, 3 and 9 Helicopter
• Motor Replacement Procedure Salvation 1 , 3 and 9 Helicopter